Spin Collar Maker

Make your own spin collars in minutes.
Just cut galvanized stock (24 gauge & lighter) to width and length, set the diameter from 4" to 16", and push the blank against the automatic stop.
A synchronized die notches the lead edge for easy spin-installation on the job site. The notched piece is then pushed past the stop, feeding the part into the rollformer and finally into the automatic crimping and curling operations.
Two models are available - Model 6 (2" to 6") and Model 12 (2" to 12").

Capacity: 24-30 Gauge, 4" - 16" curling diameter
Speed: 40 feet per minute